The Fluke i30s current clamp is based on Hall Effect technology for use in measurement of both DC and AC current. The i30s may be used in conjunction with oscilloscopes and other suitable recording instruments for accurate non-intrusive current measurement.
| Electrical specifications |
| Current range | |
| Measuring range | |
| Output sensitivity | |
| Accuracy (at +25 °C) | |
| Resolution | |
| Load impedance | |
| Conductor position sensitivity |
|
± 1 % relative to center reading |
|
| Frequency range | |
| Phase shift below 1 kHz | |
| Temperature coefficient | |
| Power supply |
|
9 V Alkaline, MN1604/PP3, 30 hours, low battery indicator |
|
| Working voltage (see Safety Standards section) | |
| General specifications |
| Maximum conductor size | |
| Output connection |
|
Safety BNC connector, supplied with safety 4 mm adapter |
|
| Output zero |
|
Manual adjust via thumbwheel |
|
| Cable length | |
| Operating temperature range | |
| Storage temperature range (with battery removed) | |
| Operating humidity |
|
15 % to 85 % (non-condensing) |
|
| Weight | |
| Safety standards |
|
BS EN 61010-1: 2001 |
|
BS EN 61010-2-032: 2002 |
|
BS EN 61010-031: 2002 |
|
300 Vrms, Category III, Pollution Degree 2 |
|
Use of the probe on uninsulated conductors is limited to 300 V acrms or dc and frequencies below 1 kHz. |
|
| EMC Standards |
|
EN 61326: 1998 +A1, A2, & A3 | |
No user reviews available.
