Altek 134-2 - Altek 134-2 Milliamp Calibrator on MyMeterStore.com

The Altek 134-2 Pocketcal Milliamp Calibrator will check, calibrate and measure all your current signal instruments in a 4 to 20 milliamp DC loop. Use at every point in your loop. Source & Read 0.00 to 24.00 mA, Simulate a Two-Wire Transmitter or use the Altek 134-2 Pocketcal to simultaneously Power & Measure your Two-Wire
Transmitters. Toggle the display to show milliamps or percent of 4 to 20.

Calibrate recorders, digital indicators, stroke valves or any other instruments that get their input from a 4 to 20 mA loop. Easily set any value to within 0.01 mA with the
speed sensitive digital potentiometer.

The �QUIK-CHEK� pushbuttons provide rapid checking of 4.00, 20.00 and a third point between 0.00 to 24.00 mA.

Check loop wiring and receivers by using the Altek 134-2 in place of a 2-Wire transmitter. Simulate a changing process input to check loop response and control settings. The Altek 134-2 Pocketcal Milliamp Calibrator uses any loop power from 3 to 45V DC.

Check controller outputs or measure the milliamp signal anywhere in the loop. The Model 134-2 measures 0.00 to 24.00 mA signals with much greater accuracy than
a typical multimeter. Toggle the display to show milliamps or percent of 4 to 20.

Simultaneously measure the output of a 2-Wire Transmitter while using the internal batteries to supply up to 14V DC to power the transmitter. Handy for checking
transmitters in the field or on the bench.

What's Included?

Attached test leads with alligator clips
Data Sheet on 134-2
Manufacturer's Statement of Calibration Practices
Three Year Warranty

More Information

See the Altek 134-2 Brochure